Marine Electronics Forum - Mounting Cup for Clarion MW1?

THE HULL TRUTH is the world's largest FREE network for the discussion of Boating & Fishing. Whether you're researching a new boat, or are a seasoned Captain, you'll find The Hull Truth Boating & Fishing Message Forum contains a wealth of information from Boaters and Sportfishermen around the world.




View Full Version : Mounting Cup for Clarion MW1?


knotgeezers
06-24-2010, 10:29 AM
Does anybody know of a mounting cup available for the Clarion MW1 remote unit? I have limited room to cut the 3" hole the unit requires, so was wondering if anybody has an alternative?

Found a VDO 1 gauge mount that is 3 1/8"..... so far.

Any help would be appeciated. ;?


Steve_250
06-25-2010, 10:23 AM
You have exposed terminals and wires on the back, I would be concerned about damaging them.
Not to mention the fat ugly wire.
I installed one where my old one was, drilled out the hole, nice install.
Is there anywhere else you can think to mount it?
It doesn't have to be right on the helm.
Oh, your Clarion stereo remote will work with it too!!!!!
Just aim at the CM-1 and zap!

knotgeezers
06-26-2010, 08:21 AM
Well .... I found a gauge mounting cup for the unit. It fits almost perfectly and will allow me to mount the unit where I can see and use it easily. Mounting cup for 3" ISSPRO Racing Gauges for anyone looking in the future.

My problem was that I don't have any more room at the helm without completely reaaranging the layout. A 3 1/2 inch round device can be hard to find a spot!




Search Engine Friendly URLs by vBSEO 3.2.0