Shipyard Isl. Marine Engine Parts - Yamaha bundle boot needed
THE HULL TRUTH is the world's largest FREE network for the discussion of Boating & Fishing. Whether you're researching a new boat, or are a seasoned Captain, you'll find The Hull Truth Boating & Fishing Message Forum contains a wealth of information from Boaters and Sportfishermen around the world.
06-18-2008, 02:15 PM
I'm looking for a pair of rubber or plastic boots that will cover all the Yamaha wires/cables where they exit the transom. Do you guys carry this?
Something like this?
06-18-2008, 08:07 PM
yup that's it. how do I get 2 of 'em?
Reel Pursuit - 6/18/2008 10:07 PM yup that's it. how do I get 2 of 'em?
Either call us or shoot me an email to [email protected]
I also need to know the engine model for the correct grommet for the engine end. And the length of hose.
06-23-2008, 10:59 AM
Thanks Andy. I'll take the measurements and get in touch. They will be for F250s. Just a question: how do these get installed after the fact? Do I have to disconnect the bundle at the motor first? I'm not sure I'd want to attempt that. The only thing I can think of is to cut the whole thing length-wise and then use zip ties to hold it together.
You have to disconnect the 'bundle" at the engine. Its not that hard......and there is nothing to readjust. If you take your time.......its easy.
Forget cutting the hose.......it defeats the purpose.
06-23-2008, 01:22 PM
that's what I figured. I'll take a look at it and see what my confiidence level is. Also, what is the tube actually called?
The blue tube is called rigging tube, and the engine fitting endis called the engine grommet, and the boat end is called the transom grommet.
07-21-2008, 01:18 PM
Andy, Do you have these rigging tubes for 2x 2008 f150s installed on my 2000 G. bay 2670...........this looks like much nicer installation than the current leaky boot arrangement.........price?
Shoot me an email to [email protected]
Also let me know how much rigging tube you need.