yamaha rpm issue - The Hull Truth

august01 · 05-26-2009, 12:58 PM

My 2001 225 yamaha has run perfectly until after I hit something on bottom while idling into a shallow slip. The hit caused the engine to shut off. It started up fine with no visible damage anywhere - prop and surounding area look fine.

Ever since then, when up on plane and running at 4,000 rpms , the rpm gauge intermittently runs up to 5,000 or so then back down to 4,000. There is no engine sound or speed change during this rpm run up. Engine continues to run smooth at the same mph speed.

I am not convinced that the hit in the slip incident and this rpm issue are related but this problem seemed to start right after. Any ideas would be appreciated. Thanks, Tom

A1 Outboard · 05-27-2009, 07:03 AM

It is possible that the rubber hub in your prop was damaged by the hit. Remove the prop and look for rubber oozing out around both ends of the center hub. You need to carefully check the front of the gearcase and skeg for damage. This area when damaged can cause interruption of water flow to the prop.